750-101 SPRINT SS Ti PARTS : EXHAUST

Complete centre and rear exhaust section to suit 750 101 Series Sprints Speciale cars Made in Italy by IMASAF - OE Quality steel exhaust systems since 1954!

Exhaust manifold nut to suit 101 and 105 series twin-cam engines. 8 fitted per cylinder head. These are a smaller outer diameter than the original which makes tightening easier as you have more access room around the nut.

Exhaust/inlet manifold stud 34mm to suit all 101 and 105 series twin-cam engines. There are 8 on the exhaust side and 7 on the inlet side, of which three are longer and not currently available. Please measure your existing inlet studs as...

Copper cylinder head to exhaust manifold gasket to suit all 101 and 105 series engines. Four required per car.

Rubber hanger for the exhaust system on all 105/115 series cars. Normally two per car. Also fitted to 750, 101, 102 (2000) and 106 (2600) Series cars. Note. Metal plates and inserts for the rubber hangers are available under item code EX036.

Set of 2 metal plates and the insert for the bolt hole on the rubber exhaust hanger on all 105/115 series cars. Two sets are required for each hanger, usually 4 per car (2 rubber hangers). Also fitted to 750, 101, 102 (2000) and 106 (2600)...

Rubber bush for gearbox to exhaust hanger (2 per car). Fits 750 & 101 series cars, as well as 1900s, 102 series 2000 & 106 series 2600 cars as well.

Bracket which is bolted to pedal box casting, where the heat protection plate fixes on to it, protects the Brake master cylinder from heat generated by the exhaust system.

Cylinder head to exhaust manifold gasket to 750 Series 1300 engines. 4 required per engine.

Exhaust manifold to downpipe gasket to suit 3 bolt flanges on 750 Series engines. 2 required per car. Should also suit cars with single downpipe exhaust systems.

Replacement exhaust system clamp to suit all standard sized (54mm) 750, 101 and 105 series exhaust systems. Usually one clamp per car, located on the join between the front and middle exhaust sections.